[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. When drilling or chipping into walls, floors or wherever "live" electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF THE TOOL! [. . . ] Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. CAUTION: There is tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Do not pull the switch trigger when the reversing switch lever is in the neutral position. Coat the bit shank head beforehand with a small amount of bit grease (about 0. Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Select one of the two modes suitable for your work needs by using this knob. For rotation only, turn the knob so that the arrow on the knob points toward the M symbol on the tool body. For rotation with hammering, turn the knob so that the arrow on the knob points toward the r symbol on the tool body. If you operate the tool with the knob positioned half-way between the mode symbols, the tool may be damaged. The torque limiter will actuate when a certain torque level is reached. As soon as the torque limiter actuates, switch off the tool immediately. Never use "rotation with hammering" when the drill chuck assembly is installed on the tool. [. . . ] I metall kan du borra upp till 13 mm i diameter, och i trä upp till 32 mm i diameter. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]